Gradall 534B (9100-3023) Operation Manual User Manual download pdf (Page 9)

Stopping the Engine

Operate engine at idle speed for a few minutes

before turning it off. This allows engine coolant

and lubricating oil to carry excessive heat away

from critical engine areas.

Do not “gun” engine before shut down; this

practice causes raw fuel to remove oil film from

The safety, efficiency and service life of your unit

will be increased by performing the operational

checks listed below. Items preceded by an asterisk

(*) are optional and may not be furnished on your

machine. Check items during warm-up period.

When engine warms to operating range, check

the following Items:

cylinder walls and dilute lubricant in crankcase.

To stop engine, allow engine to run at idle for a few

minute and then turn key counterclockwise to stop

position. Be sure to remove key from ignition switch

before leaving cab.

WARM UP & OPERATIONAL CHECKS

(to be performed at beginning of each work shift)

Complete all required maintenance before operating unit.

Continued operation with hydraulic fluid

by-passing the filter (yellow flag

showing) can cause severe damage to

hydraulic system components.

Forward and reverse travel in all gears

“Inching” travel-should be smooth through

full pedal travel

Horn and back-up alarm

All boom and attachment functions - full stroke

in both directions

Hydraulic Filter Condition Indicator - observe

torque converter temperature edge after start-

ing normal operation. When needle has been in

operating range for an hour or so, stop handler

in a safe area and set parking brake. With

engine running, check hydraulic filter

condition indicator. When yellow flag fills

indicator window, filter is clogged and

hydraulic oil is bypassing filter. Filter must be

changed before reaching bypass condition

(change before yellow flag reaches midpoint of

window).

10.

Heater, defroster and windshield wiper

Operating lights and rotating beacon

Low brake pressure light-should go out with

engine running above idle

Ammeter-should show low charging rate after

charging system has replaced starting drain

*1.

*2.

Service brake, parking brake and Mico brake

lock.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Comments to this Manuals

No comments

Gradall 534B (9100-3023) Operation Manual User Manual Page 9

Comments to this Manuals

Related products and manuals for Hoist Gradall 534B (9100-3023) Operation Manual